Overview

Address: California, United States (US)
Shop Hours: 6:00 - 22:00
Email: <a href="/cdn-cgi/l/email-protection#ee9d8b9c988b9cae988f82988b8c81829a809b9ac08d8183" style="word-break: break-all;"> <span class="__cf_email__" data-cfemail="ddaeb8afabb8af9dabbcb1abb8bfb2b1a9b3a8a9f3beb2b0">[email&#160;protected]

The iFlight GM6208-150T is a brushless gimbal motor with encoder for camera stabilization setups, suitable for DSLR-sized cameras including CANON 5D MARK II / MARK III, and for large multi-rotor platforms lifting RED Epic & DSLR-sized gear. It uses a brushless direct-drive stabilization principle similar in concept to servo-based gimbals.

Key Features

Brushless direct-drive gimbal motor design
Integrated AS5048A encoder (aluminum case included)
Hollow shaft design for pass-through routing
24N/28P motor configuration

Specifications

Model	GM6208
Motor outer diameter	69.5 0.05 mm
Configuration	24N/28P
Motor height	32 0.2 mm (included with encoder housing)
Hollow shaft (OD)	25 -0.01/-0.015 mm
Hollow shaft (ID)	22 +0.05/+0 mm
Wire length	610 3 mm
Cable	AWG #24
Motor weight	265 0.5 g
Wire plug	2.5 mm Dupont connector
No-load current	0.08 0.1 A
No-load voltage	20 V
No-load RPM	209 to 231 RPM
Load current	1.2 A
Load voltage	20 V
Load torque	2600 to 3600 gcm
Motor internal resistance	32 ohm 5% (resistance varies with temperature)
High voltage test	DC 500 V, 1 mA @ 2 sec
Rotor housing runout	0.1 mm
Steering (axle extension)	Clockwise
High temperature test	60 C for 100 hours; motor works normally after 24 hours at room temperature
Low temperature test	-20 C for 100 hours; motor works normally after 24 hours at room temperature
Maximum power	25 W
Working current	3-5S
Working temperature	-20 to 60 C; 10 to 90% RH