Overview

The Hobbywing XRotor V9626 IPC 12S VTOL motor (V9626 160KV / HV-9626-160KV) is designed for VTOL rotor power series applications and supports Intelligent Propeller Control (IPC). Key rated and maximum performance figures include max power of 9340W and max thrust of 38.5kg.

For compatibility checks (propellers, ESC, wiring), contact [email protected] or visit https://rcdrone.top/.

Key Features

Intelligent Propeller Control (IPC): low power consumption with precision positioning; propeller stop positioning can reduce cruising resistance and improve flight time when used with a Hobbywing ESC; standardized installation interface.
Optimized magnetic circuit design for improved performance, supporting high torque and strong burst power.
Stator process: high standard silicon steel sheet, rust proof, with 180C high temperature resistance paint-coat.
Enamelled wire temperature rating: 200C; magnet temperature rating: 180C.
Isolation test: 500V AC high voltage resistance test.
Protection level: IP5; bearing: water proof bearing.
Dynamic balance: 15mg.
High-load figures shown: motor weight 975g; thrust-to-weight ratio up to 39:1; suitable for VTOL take-off weight of 65kg (conventional four-rotor VTOL layout).
Maximum thrust test note: 38.5kg (tested with MSC 32×10.5 propellers under 46V at full throttle in the laboratory).

Specifications

Model	V9626 160KV
Series / Marking	V9626 160KV; HV-9626-160KV
Motor size	104.5*H64.2mm
Stator size	96mm
Slot & pole	36N 42P
KV	160
Battery (LiPo)	12S LiPo
No-load current	9.45A
Maximum current (Non-hermetic, ambient temperature 25C)	171.5A
Resistance	8.95m
Max power	9340W
Max thrust	38.5kg
Rated power input	2500W
Rated power output	2125W
Weight (with wire)	975g
Wire size	enamelled wire outlet
Wire length	150 mm
Motor axle diameter	10mm
Props mounting dimensions	4M3@D20mm + 4M4@D23mm
Motor mounting dimensions	4M5@D50mm
Protection level	IP5
Bearing	Water proof bearing
Dynamic balance	15mg
Stator process	High standard silicon steel sheet, rust proof, 180C high temperature resistance paint-coat
Enamelled wire	200C
Magnet	180C
Isolation test	500V AC high voltage resistance test
Thrust-to-weight ratio (shown)	39:1
VTOL take-off weight (shown)	65kg (conventional four-rotor VTOL layout)
CAD reference dimensions (shown)	64.20 mm; 58.20 mm; 55.20 mm; 65 mm; 30; 20; 4-6; 4-3.20

Applications

VTOL rotor power series motors
Drone application scenarios (shown)

Recommended application combinations (provided)

Motor: V9626 160KV
Propeller: MSC 30×9.8 / MSC 32×10.5 (also provided: MFP 30×9.8 / MFP 32×10.5)
ESC: XRotor Pro-H200A-14S-BLDC-IPC (also provided: XRotor Pro H200A 14S BLDC IPC)
Battery: 12S LiPo
Thrust/rotor: 12~16kg
Takeoff weight of quadrotor: 50~64kg

Performance

V9626 160KV + MFP 30×9.8Load performance parameters

V9626 160KV + MFP 30×9.8Motor Propeller Pull Test Data

Voltage(V)	Propeller	Throttle(%)	Thrust(g)	Current(A)	Power Input(W)	Speed(RPM)	Efficiency(g/W)	Torque(Nm)	Power Output(W)	Temperature()
46V (12S LiPo)	MFP 30×9.8	33%	4578	11.2	514.0	2349	8.9	1.25	436.9	83.2C
35%	5109	12.7	585.2	2479	8.7	1.41	497.4
37%	5667	14.4	663.9	2608	8.5	1.59	564.3
39%	6250	16.3	750.0	2735	8.3	1.77	637.5
42%	7163	19.4	892.6	2921	8.0	2.05	758.7
45%	8119	22.8	1051.1	3100	7.7	2.34	893.4
48%	9113	26.6	1225.1	3273	7.4	2.64	1041.3
51%	10145	30.7	1414.6	3440	7.2	2.96	1202.4
54%	11213	35.2	1619.9	3602	6.9	3.28	1376.9
57%	12318	40.0	1841.8	3761	6.7	3.62	1565.5
60%	13464	45.2	2081.4	3917	6.5	3.97	1769.2
63%	14652	50.9	2340.2	4072	6.3	4.33	1989.1
66%	15885	56.9	2620.1	4226	6.1	4.71	2227.1
69%	17166	63.5	2923.4	4381	5.9	5.11	2484.9
72%	18498	70.7	3252.9	4535	5.7	5.53	2764.9
75%	19884	78.5	3611.1	4689	5.5	5.98	3069.5
78%	21324	86.9	4001.1	4842	5.3	6.45	3401.0
81%	22818	96.2	4425.5	4992	5.2	6.94	3761.7
84%	24366	106.2	4886.4	5138	5.0	7.47	4153.4
87%	25962	117.0	5384.6	5279	4.8	8.02	4576.9
90%	27603	128.6	5919.7	5414	4.7	8.59	5031.7
100%	32977	169.5	7800.5	5828	4.2	10.46	6630.4

The above data is measured by HobbyWing laboratory at room temperature 25, sea level, change the throttle input adjustment, the motor temperature is 65% and the throttle runs for 10 minutes, for reference only.

V9626 160KV + MFP 32×10.5Load performance parameters

V9626 160KV + MFP 32×10.5Motor Propeller Pull Test Data

Voltage(V)	Propeller	Throttle(%)	Thrust(g)	Current(A)	Power Input(W)	Speed(RPM)	Efficiency(g/W)	Torque(Nm)	Power Output(W)	Temperature()
46V (12S LiPo)	MFP 32×10.5	33%	5823	13.9	638.1	2286	9.1	1.75	542.4	87.1C
35%	6480	15.8	725.4	2406	8.9	1.96	616.6
37%	7171	17.9	823.6	2526	8.7	2.18	700.1
39%	7889	20.3	932.3	2646	8.5	2.41	792.5
42%	9009	24.2	1113.8	2821	8.1	2.77	946.7
45%	10170	28.6	1315.9	2992	7.7	3.14	1118.5
48%	11365	33.4	1536.9	3157	7.4	3.53	1306.3
51%	12589	38.6	1775.8	3317	7.1	3.92	1509.4
54%	13841	44.2	2032.2	3472	6.8	4.32	1727.4
57%	15123	50.1	2306.5	3623	6.6	4.72	1960.5
60%	16439	56.5	2599.5	3772	6.3	5.14	2209.6
63%	17793	63.3	2913.1	3919	6.1	5.57	2476.1
66%	19191	70.6	3249.6	4065	5.9	6.01	2762.2
69%	20638	78.5	3612.0	4210	5.7	6.48	3070.2
72%	22140	87.0	4003.7	4355	5.5	6.97	3403.2
75%	23703	96.2	4428.4	4500	5.4	7.48	3764.1
78%	25329	106.2	4889.8	4645	5.2	8.03	4156.4
81%	27020	117.1	5391.4	4788	5.0	8.61	4582.7
84%	28776	129.0	5935.7	4929	4.8	9.22	5045.4
87%	30592	141.7	6523.8	5066	4.7	9.86	5545.2
90%	32463	155.4	7154.1	5200	4.5	10.53	6080.9
100%	38584	202.9	9340.0	5598	4.1	12.59	7939.0

Details

The XRotor V9626 motor drawing details the overall size and multiple mounting hole patterns to help plan fitment and hardware selection.

The XRotor V9626 160KV VTOL motor features a vented aluminum housing, central mounting hub, and extended leads for easier routing.

The Hobbywing XRotor HV-9626 160KV motor is listed at 975g with a quoted maximum thrust of 38.5kg and a 39:1 thrust-to-weight ratio.

The XRotor V9626 VTOL motor is positioned for drone applications such as emergency response operations.

The Hobbywing XRotor V9626 VTOL motor features a vented black housing with a clean, low-profile can design for compact installations.

The XRotor V9626 IPC motor uses Intelligent Propeller Control for precise propeller stop positioning with a standardized installation interface.

Recommended setups pair the V9626 160KV motor with a 12S LiPo, MSC 30×9.8 or 32×10.5 propeller, and XRotor Pro-H200A-14S-BLDC-IPC ESC.

Add a Review

Your email address will not be published. Required fields are marked *

Related Products

Sale

GEPRC SPEEDX2 0802 17000KV/22000KV Brushless Motor - Suitable For DIY RC FPV Quadcopter Drone Accessories Replacement Parts

$23.47 $29.34

DC15V-36V-15A 500W Brushless Motor Controller Hall Motor Balanced Car Driver Board with Hall Drive

Sale

Shopping Cart

Menu

Hobbywing XRotor V9626 IPC 160KV 12S VTOL Motor (HV-9626-160KV) 9340W, 38.5kg Thrust