T-Hobby AMZ18*10 Carbon Fiber Propeller for 65″-69″ 3D Planes, 18inch Diameter / 10inch Pitch

Overview

This T-Hobby AMZ Series carbon fiber propeller is model AMZ18*10, designed for 3D flight and aerobatic maneuvers. The image text states it is forged as an exclusive propeller for 3D flight and aims to minimize propeller deformation for consistent power output.

For customer service and order support, contact https://rcdrone.top/ or email [email protected].

Key Features

• AMZ Series carbon fiber propeller for 3D flight (“3D Flight Essence” text shown).
• Material and structure claims shown: T800 large-mesh carbon fiber.
• Claimed improvements shown: 16% dynamic intensity; 22% fatigue intensity.
• Claimed response times shown (compared to normal carbon propeller): 0.11s acceleration time; 0.17s deceleration time.
• Claimed efficiency improvements shown: 11% rudder efficiency; 9% improved aerodynamic efficiency.
• “T-MOTOR Series Integrated Propeller” is listed in the specification image.

Specifications

Propeller Specifications (as shown)

Engineering Drawing Dimensions (unit not specified on the image)

Power System Matching (as shown for AMZ 18*10)

Whats Included

• Packaging Box*1 (Volume: 540*60*30mm)
• Propeller*1
• Prop Bag*2

Applications

• 3D planes / 3D aircraft: 65″-69″ (90E) (as shown)
• Hovering, accelerating, and high-speed flight (as shown)

Notes (from image)

• Prop marked with “L” is for CW; “R” is for CCW (aerial view).
• Use caution: spinning propellers may cause harm.
• Use within the recommended maximum thrust range; exceeding the thrust limit may damage the propeller blades.
• Do not test blade strength by hand-bending; this does not replicate actual stress conditions and may cause blade damage.
• Ensure all accessories are mounted properly.
• Check propellers before flight; replace if a fault is found.
• Storage requirements shown: avoid corrosive gases and hazardous environments; maintain ambient conditions within temperature range -10C to 50C and relative humidity <=85% RH; adhere to these parameters during long-term storage.
• Apply anaerobic screw locking glue of medium or above strength when installing propellers onto motors.

Details

The T-Hobby AMZ carbon fiber propeller features a woven-look finish and clear 18×10 size marking for easy identification during setup.

The AMZ 1810 prop is matched with AM670 KV480/KV520 motors and an AM116A 38S ESC for 6569 inch 3D aircraft setups.

The AMZ18*10 carbon fiber propeller is listed as 18-inch diameter with 10-inch pitch, CF+epoxy material, and includes one prop plus two prop bags.